This type of cycloid hydraulic motor is also installed in the embedded gear roller bearings, with roller bearings motor can give a higher opening and operation torque, roller bearings reduce friction, thus enhancing the efficiency, even at a very low speed ratio output shaft can form a smooth output. According to the change of the I/O total flow direction to make the motor fast commutation, and in the two directions to cause equal use value of torque, in the use of what problems should be paid attention to? The manufacturer will introduce it to you in detail.

In the use of quantitative analysis motor, if the starting and parking stability is expected, XSM7 series hydraulic motor should take the necessary working pressure control or flow monitoring mode in the circuit design

The development prospect analysis and forecast report is based on the market demand analysis of the current situation of historical and cultural development trend, supply and demand, market competition layout, economic situation, the development of the middle and lower reaches of the industry, and the market demand in the lower reaches of the industry. The future development trend of cycloid hydraulic motor field, market demand, market competition development trend, separation of the middle and downstream market demand to carry out judgment and forecast analysis.

1. When the inertia force of the pushed parts is large, if it is stipulated that the braking system or reverse or smooth running can be achieved in the short term, the valve cache should be set in the oil return channel to avoid the large impact of the hydraulic press resulting in the destruction of safety accidents.

2, in the use of quantitative analysis motor, if the starting and parking stability is expected, the necessary working pressure control or flow monitoring method should be adopted in the circuit design.

3. When the hydraulic motor is used as the driving force of the lifting equipment or moving equipment, the XWM1 series hydraulic motor should set the limit network speed valve as far as possible to prevent the lifting equipment from falling fast or the car and other lifting mechanism from overspeed, which will cause obvious safety accidents.

4, because the hydraulic motor will always leak, so the hydraulic motor inlet and outlet off to achieve the braking system, it will still appear slowly moving, when the need for long-term braking system, should be set to avoid rotation of the braking system.

5, must load when starting, should pay attention to the hydraulic motor starting torque standard value, because the hydraulic motor starting torque is smaller than the rated torque, if ignored may make the work unit difficult to run.

6, because the XWM2 series hydraulic motor pump oil back pressure type (outlet working pressure) is higher than atmospheric pressure, so the motor drainage pipeline must be directly led back to the oil tank, can not be connected with the hydraulic motor return pipeline.

The motors of each series are a variety of displacement options to meet various speed and torque requirements. Cycloid hydraulic motor is a kind of medium and small speed high torque hydraulic motor, which adopts one shaft flow distribution insert gear fixed motor rotor pair.